Flatbed Truck Near Whittier, California
Flatbed and stake bodies, decks, headache racks and cab repair. Work in this scope runs $750 to $12,000 at OCRV Center, billed from the published rate card and evaluated in shop before anything is authorized. The facility sits in Yorba Linda, roughly twenty minutes from Whittier down the I-605.
What this scope covers
Flatbed and stake bodies, decks, headache racks and cab repair.
It sits inside the commercial trucks program at OCRV Center, which is where the neighbouring scopes and the shared process live. Everything is performed in shop at the Yorba Linda facility, and there is no mobile or roadside option for this work.
- Program
- Commercial Trucks
- Labor rate
- $260 per hour, mechanical and electrical
- Typical band
- $750 to $12,000
- Labor hours
- 5 to 60 hours
- Evaluation
- Priced and credited against an authorized repair. Collision teardown is one hour at $210, RV systems is $150, in depth diagnostic is one hour at $285.
- Where
- 23281 La Palma Ave, Yorba Linda, CA 92887. Serving Whittier and Los Angeles County.
Published rate card
Flatbed Truck price band
Bands are the working range for this scope at OCRV Center, not a quote. Body and paint labor bills at $210 per hour and mechanical at $260. The exact figure comes from the priced evaluation, which is credited against an authorized repair.
Sidewall cross section
What the commercial trucks wall is actually made of
Every water and delamination decision on this vehicle comes back to the layer order in the sidewall. Outermost layer first:
- 01FRP or aluminum panel
- 02Structural post
- 03Foam or balsa core on reefer bodies
- 04Interior scuff liner
- Bond system
- Bonded FRP panel adhesive on dry vans, riveted post and panel on aluminum bodies
- Moisture path
- Water enters at roof bows, the front bulkhead joint and rear frame corners, then tracks along the post and surfaces as a stained or bulging interior liner.
- Crossover point
- A delaminated reefer liner is replaced by the panel, not patched. Insulation value does not come back once the core is wet.
- Where this is evaluated
- In shop at the Yorba Linda facility. Moisture mapping is part of the priced evaluation and is credited against an authorized repair.
Common questions
What does flatbed truck cost at a Whittier area shop?
$750 to $12,000 is the working band at OCRV Center, which is 5 to 60 hours of labor plus parts and materials. The exact figure comes from a priced evaluation that is credited against an authorized repair. Body and paint labor bills at $210 per hour, mechanical and electrical at $260.
Do I have to bring the vehicle in for flatbed truck?
Yes. OCRV Center is an in shop operation with no mobile service and no roadside work. The facility is at 23281 La Palma Ave, Yorba Linda, about twenty minutes from Whittier on the I-605.
Will insurance cover flatbed truck on my commercial trucks?
If the damage is from a covered loss, generally yes, and the shop bills direct with every major carrier. Wear, age and deferred maintenance are usually owner pay. The evaluation tells you which side of that line the damage falls on before you file.
How does water reach this area on a commercial trucks?
Water enters at roof bows, the front bulkhead joint and rear frame corners, then tracks along the post and surfaces as a stained or bulging interior liner. That path is why the entry point and the damage you can see are rarely in the same place, and why the evaluation maps the whole run rather than the stain.
More commercial trucks scopes
- Service and Utility Truck
Service body installation, repair and compartment work on utility trucks.
- Cab and Chassis
Bare cab and chassis units, collision repair and refinish before a body goes on.
- Box Truck
Dry van box bodies, rear frames, roll up doors and the cab in front of them.
- Refrigerated Truck
Reefer bodies, liner delamination and the insulated panel behind it.
Bring it in
Insurance walk ins are welcome. The teardown hour is priced at $210 and credited against an authorized repair, so the evaluation is not a cost you lose if the work proceeds.
23281 La Palma Ave, Yorba Linda, CA 92887. Monday to Friday 8:00 AM to 5:00 PM, Saturday 9:30 AM to 3:00 PM.