Commercial Trucks: Body, Structural and Systems Repair Near Whittier
Box, reefer, flatbed and service trucks. Body and cab work on the vehicles that lose money for every day they sit. OCRV Center covers 5 distinct scopes inside this program, all performed in shop at the Yorba Linda facility. Owners across Whittier and Los Angeles County reach it on the I-605 and SR-72.
5 pages
Vehicle types we take
- Box Truck
Dry van box bodies, rear frames, roll up doors and the cab in front of them.
- Refrigerated Truck
Reefer bodies, liner delamination and the insulated panel behind it.
- Flatbed Truck
Flatbed and stake bodies, decks, headache racks and cab repair.
- Service and Utility Truck
Service body installation, repair and compartment work on utility trucks.
- Cab and Chassis
Bare cab and chassis units, collision repair and refinish before a body goes on.
Published rate card
What this costs
Bands are the working range for this scope at OCRV Center, not a quote. Body and paint labor bills at $210 per hour and mechanical at $260. The exact figure comes from the priced evaluation, which is credited against an authorized repair.
Sidewall cross section
What the commercial trucks wall is actually made of
Every water and delamination decision on this vehicle comes back to the layer order in the sidewall. Outermost layer first:
- 01FRP or aluminum panel
- 02Structural post
- 03Foam or balsa core on reefer bodies
- 04Interior scuff liner
- Bond system
- Bonded FRP panel adhesive on dry vans, riveted post and panel on aluminum bodies
- Moisture path
- Water enters at roof bows, the front bulkhead joint and rear frame corners, then tracks along the post and surfaces as a stained or bulging interior liner.
- Crossover point
- A delaminated reefer liner is replaced by the panel, not patched. Insulation value does not come back once the core is wet.
- Where this is evaluated
- In shop at the Yorba Linda facility. Moisture mapping is part of the priced evaluation and is credited against an authorized repair.
In shop process
How the job actually runs
- Step 01
Get the vehicle to Yorba Linda
Drive or tow the vehicle to 23281 La Palma Ave, Yorba Linda. Insurance walk ins are welcome and no appointment is needed to start a collision teardown.
- Step 02
Priced evaluation
Collision teardown is one hour at $210, an RV systems evaluation is $150, and an in depth diagnostic is one hour at $285. Every one of those is credited against an authorized repair, so the evaluation is not money you lose.
- Step 03
Scope and carrier
You get the scope in writing with rate card figures against it. If a carrier is involved the shop bills direct and handles supplements on line items the adjuster missed.
- Step 04
Authorize, then the deposit applies
Jobs over $2,000 take a 50 percent deposit at authorization, and jobs over $10,000 take a further 25 percent when parts land. OCRV Center orders nothing before you authorize it.
- Step 05
The work
Structural and moisture work closes out before any finish goes back on. A delaminated reefer liner is replaced by the panel, not patched. Insulation value does not come back once the core is wet.
- Step 06
Pickup
Final balance is due at pickup. Card payments over $1,000 carry a 3.5 percent surcharge, which passes through the merchant fee rather than burying it in the labor rate.
Common questions
What is included in the commercial trucks program at OCRV Center?
Box, reefer, flatbed and service trucks. Body and cab work on the vehicles that lose money for every day they sit. The program covers 5 scopes: box truck, refrigerated truck, flatbed truck, service and utility truck, cab and chassis. All of it happens in shop.
How long does commercial trucks work usually take in Whittier?
Labor bands across this program run from a few hours to several hundred. Parts availability drives the calendar more than labor does, and special order parts require a full non refundable deposit at the time of order, so the schedule is set once parts are confirmed.
Where does commercial trucks repair stop and replacement start?
A delaminated reefer liner is replaced by the panel, not patched. Insulation value does not come back once the core is wet. That threshold is a structural judgment, not a preference, and it is made during the priced evaluation rather than after teardown has already been billed.
What needs doing?
Every service program below takes this vehicle. Pricing bands are on each one.
Scope boundary
What this shop does not take
No mobile service. Every job happens at the facility.
No roadside assistance and no on site evaluation.
No engine rebuild and no internal engine machining.
No transmission rebuild and no drivetrain overhaul.
No DOT inspection and no DOT certification.
No emission testing and no emission certification.
No telematics installation and no fleet software.
No fleet consulting and no driver training programs.
Everything above is work OCRV Center declines rather than work it performs poorly. The facility is a body, paint, structural and onboard systems shop, and it is an in shop operation.
Bring it in
Insurance walk ins are welcome. The teardown hour is priced at $210 and credited against an authorized repair, so the evaluation is not a cost you lose if the work proceeds.
23281 La Palma Ave, Yorba Linda, CA 92887. Monday to Friday 8:00 AM to 5:00 PM, Saturday 9:30 AM to 3:00 PM.